Basic cylinder 
1 to take out the appropriate length of wool. To pave the way evenly, the wool forward volume 
2 the wool is placed on the working mat and the light is fixed on the fixed surface. 
3To roll one side of the thorn, be sure to stab the 
4When the half felt, the shape of the two ends is begun to be changed into a plane. 
5 then continue to poke the edge of the rolling edge, if there is a concave part can be used to make up the wool 
6 until the wool became more compact, fully felt so far 
Basic sphere 
1 remove the amount of wool, wool gently folded, rolled up into a fluffy cylinder. 
2, the two ends of the fluffy cylinder are overlapped and arranged on the working mat. 
3 While rolling side poke thorn, be careful not to tie the hand. 
4 in the felting process, need to avoid ball rolling, deformation. 
5 at the beginning of the sense of the poke in the process of resistance, the ball has been semi felt. At this time can be aimed at the wool ball repair, including depression, expansion, etc.. 
6 after the completion of repair can continue to tighten the felting wool ball. 
Sheet tutorial 
1 to lay the wool first. 
2 will be a section of wool folded up. 
3 Fold up, the whole into a rectangle, on the work pad, with a poke at the end of the last covered with a needle to cover the layer of wool. 
4 first stab at a side, until the semi felt (shape has been roughly fixed, but also soft state), and then to the other side to continue to poke to the semi. 
5 continue to take turns trimming surfaces and edges, until the whole shape became small, thin, compact, fully felt. 

Disc, flower shape 
Wool into disc 1 will take good. 
2 to put a good wool on the working mat, with a needle in the last layer of the fixed cover of the light. 
3 One side of the rolling disc edge, while the edge of a poke at the edge of the action, not only poke a place, otherwise it will become flat. 
4 Round into general, to stab the upper and bottom disc with pin prick until flat surface. 
5 while rolling edge stab to trim the edge arc, make it more sleek and compact. 
6 compact discs do, poke a inward direction of 45 degrees at the edge of thorns with acupuncture, until the depression. 
7 with the method of the same way, in the edge of the five points out of the depression. 
8 continue to trim the edge with a needle and below, make more smooth, more compact petal shape, until completely felt.